Tandberg-data Autoloader Tandberg LTO2 Manual de usuario descargar pdf (Pagina 34)

- 18 -

Operation 2 Press the "ENTER" key.

Display: STATUS

Operation 3

Press the "arrow" key and select the LOAD command.

Display: LOAD

Operation 4

Press the "ENTER" key and define the command.

Display: Load Drv?

Operation 5

Press the "arrow" key and select "Load Slt?" .

Display: Load Slt?

Operation 6

Press the "ENTER" key and execute the command.

Display: Complete (when the command ends normally.)

Err. xxxxxx (when an error occurs. xxxxxx is the error code.)

Tip

• Loading by command is valid only when slots 8 to 10 among the fixed slots

are all vacant slots.

• When loading by command is executed, all cartridges housed in slots 5 to 7

within the magazine are moved to fixed slots.

Important

For using the Tandberg LTO2 Autoloader w/BCR

In using the LTO2 Autoloader w/BCR, slot 10 must be a free slot used

to swap a cartridge during the inventory scan process. When you load the 2

cartridges to the fixed slots, i.e. slot 8 and slot 9, you can insert the cartridges

into slot 5 and slot 6 only. If a cartridge is in slot 7, loading command is

failed and error message of "S10 forBCR" is displayed on the LCD.Then,

you remove the cartridge fro slot7 manually, and retry the loading command.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 84 85

Sin comentarios

Tandberg-data Autoloader Tandberg LTO2 Manual de usuario Pagina 34