Tandberg Data 7000 Manual de usuario descargar pdf (Pagina 60)

TANDBERG Videoconferencing SystemAdvanced use

Audio Outputs

Audio out 1 is intended for connection to TANDBERG Natural Audio, televisions or audio amplifiers.

Audio out 2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The signal is

a mix of audio from both the far end and local end (not from Audio in 5).

Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from

far end and local end (not from Audio in 6).

Audio Module: Select Natural Audio Module according to the type of Audio Module installed.

NEVER CONNECT AUDIO OUT 2 OR AUDIO OUT 3 TO A LOUDSPEAKER PLACED IN THE SAME ROOM AS THE MICROPHONES CONNECTED TO THE

SYSTEM. DOING THIS WILL CAUSE “HOWLING” AND POSSIBLE DAMAGE TO THE SPEAKER SYSTEM.

If an output is ‘Off’, no audio will be sent to that output.

Level Settings - Outputs

Adjust the audio output levels according to the parameters of the external audio equipment connected. These

levels should only be adjusted when installing new audio equipment. The default settings are correct for the

TANDBERG Natural Audio module and for most consumer electronics devices (televisions, VCRs, etc.).

The volume keys on the remote control adjust the level of output 1 (the speaker output). The volume control has

no effect on outputs 2 and 3.

NOTE

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 117 118

Sin comentarios

Tandberg Data 7000 Manual de usuario Pagina 60