Tandberg Data DPS Expansion Module Disk Pack Especificaciones descargar pdf (Pagina 19)

Unpacking and Cabling DPS Expansion Module | 13

Installing DPS Expansion Module modules

Before you mounted the DPS Expansion Module enclosure in a rack, you removed the DPS

Expansion Module modules. You must now reinstall them.

Installing the power supply modules

Install both power supply modules as follows:

1. Check for damage, especially to the rear connector on the power supply.

CAUTION

Handle the module carefully and avoid damaging the connector pins. Do not

install the module if any pins appear to be bent.

2. Slide the module into the enclosure.

3. Continue to push the module until it fully seats. You will hear a click as the handle latch

engages.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Sin comentarios

Tandberg Data DPS Expansion Module Disk Pack Especificaciones Pagina 19